Motor Wiring Register LoginHome › Forums › Electrical & Controls › Motor Wiring Click Here To ReplyTagged: Motor, Motor WIringThis topic contains 4 replies, has 2 voices, and was last updated by SuperDroid 11 months, 1 week ago. Viewing 5 posts - 1 through 5 (of 5 total)Author Posts January 26, 2014 at 6:44 pm #941 SuperDroidKeymasterThis is the discussion topic for our Motor Wiring Support page. If any of the information is unclear or you have additional questions that are not covered, let us know!http://www.superdroidrobots.com/shop/custom.aspx/motor-wiring-support/19/ April 27, 2017 at 11:35 am #4157 Nick FragaleParticipantHi,If you buy motors with encoders they come with connectors (I have the IG42 122RPM)Where can I find the mating connectors? If you could provide a digikey part number that would be wonderful. April 27, 2017 at 1:31 pm #4158 SuperDroidKeymasterMotor Connector is WM4620-ND Encoder Connector is 455-1706-ND May 16, 2017 at 10:50 am #4177 Nick FragaleParticipantGreat, thank you. But those are the wire-board connectors.Do you also have the wire-wire connector digikey numbers? May 16, 2017 at 11:10 am #4178 SuperDroidKeymasterHi, What you can do is solder the cable into the connector and put heat shrink. Attached is a picture with a similar connector doing what I mention.Attachments:You must be logged in to view attached files.Author Posts Viewing 5 posts - 1 through 5 (of 5 total) You must be logged in to reply to this topic.